[PATCH 1/3] gpio: at91: use dev_read_addr() to get base address

Masahiro Yamada yamada.masahiro at socionext.com
Tue Aug 4 07:14:41 CEST 2020


It is strange to use devfdt_get_addr_ptr(), then cast the pointer
back to uint32 because you could use devfdt_get_addr() without casting.

Convert it to dev_read_addr(), which is capable to CONFIG_OF_LIVE.

Signed-off-by: Masahiro Yamada <yamada.masahiro at socionext.com>
---

 drivers/gpio/at91_gpio.c | 2 +-
 1 file changed, 1 insertion(+), 1 deletion(-)

diff --git a/drivers/gpio/at91_gpio.c b/drivers/gpio/at91_gpio.c
index 4a8b2e6ff6..ef7984374b 100644
--- a/drivers/gpio/at91_gpio.c
+++ b/drivers/gpio/at91_gpio.c
@@ -606,7 +606,7 @@ static int at91_gpio_probe(struct udevice *dev)
 	clk_free(&clk);
 
 #if CONFIG_IS_ENABLED(OF_CONTROL)
-	plat->base_addr = (uint32_t)devfdt_get_addr_ptr(dev);
+	plat->base_addr = dev_read_addr(dev);
 #endif
 	plat->bank_name = at91_get_bank_name(plat->base_addr);
 	port->regs = (struct at91_port *)plat->base_addr;
-- 
2.25.1



More information about the U-Boot mailing list