[U-Boot] [PATCH 1/6] README: mx28_common: Keep the text within 80 columns

Fabio Estevam festevam at gmail.com
Fri May 3 20:07:57 CEST 2013


From: Fabio Estevam <fabio.estevam at freescale.com>

In order to improve readability keep the text within 80 columns.

Signed-off-by: Fabio Estevam <fabio.estevam at freescale.com>
---
 doc/README.mx28_common |   10 +++++-----
 1 file changed, 5 insertions(+), 5 deletions(-)

diff --git a/doc/README.mx28_common b/doc/README.mx28_common
index 8bacaf8..6618908 100644
--- a/doc/README.mx28_common
+++ b/doc/README.mx28_common
@@ -63,9 +63,9 @@ means "/usr/local/bin/" has to be in your $PATH.
 2) Compiling U-Boot for a MX28 based board
 -------------------------------------------
 
-Compiling the U-Boot for a MX28 board is straightforward and done as compiling U-Boot
-for any other ARM device. For cross-compiler setup, please refer to ELDK5.0
-documentation. First, clean up the source code:
+Compiling the U-Boot for a MX28 board is straightforward and done as compiling
+U-Boot for any other ARM device. For cross-compiler setup, please refer to
+ELDK5.0 documentation. First, clean up the source code:
 
 	$ make mrproper
 
@@ -150,8 +150,8 @@ NOTE: If the user needs to adjust the start sector, the "mxsboot" tool contains
 4) Installation of U-Boot into NAND flash
 -----------------------------------------
 
-To boot a MX28 based board from NAND, set the boot mode DIP switches according to i.MX28
-manual chapter 12.2.1 (Table 12-2), PORT=GPMI, NAND 1.8 V.
+To boot a MX28 based board from NAND, set the boot mode DIP switches according
+to i.MX28 manual chapter 12.2.1 (Table 12-2), PORT=GPMI, NAND 1.8 V.
 
 There are two possibilities when preparing an image writable to NAND flash.
 
-- 
1.7.9.5



More information about the U-Boot mailing list