[U-Boot] [PATCH 2/6] README: mx28_common: Do not hardcode the SSP port

Fabio Estevam festevam at gmail.com
Fri May 3 20:07:58 CEST 2013


From: Fabio Estevam <fabio.estevam at freescale.com>

MX28 can boot from SSP0 or SSP1, so it is better not to hardcode the SSP port
in the instructions.

Signed-off-by: Fabio Estevam <fabio.estevam at freescale.com>
---
 doc/README.mx28_common |    4 +---
 1 file changed, 1 insertion(+), 3 deletions(-)

diff --git a/doc/README.mx28_common b/doc/README.mx28_common
index 6618908..bd12cab 100644
--- a/doc/README.mx28_common
+++ b/doc/README.mx28_common
@@ -100,9 +100,7 @@ discussed in the following chapters.
 -----------------------------------------------------------
 
 To boot a MX28 based board from SD, set the boot mode DIP switches according
-to i.MX28 manual chapter 12.2.1 (Table 12-2), PORT=SSP0, SD/MMC master on
-SSP0, 3.3V.
-
+to i.MX28 manual chapter 12.2.1 (Table 12-2).
 
 An SD card the i.MX28 CPU can use to boot U-Boot must contain a DOS partition
 table, which in turn carries a partition of special type and which contains a
-- 
1.7.9.5



More information about the U-Boot mailing list